Kind of stumped at this point, this carb is pretty basic and the kit came with new gasket, o rings, jet needle and both jets, and the piston and springs for the enricher/choke system. Don't see any fuel coming out of the overflow. Throttle response seems a bit sluggish too. I adjusted the idle and pilot (air/fuel) to the point where it's not as bad, but it surges at low speed and get a mild backfire on occasion. It was running so rich my eyes were burning while tinkering on it. I thought that would be the problem, but after reassembly it ran pretty much the same. (I could back it out and watch it unscrew itself with engine vibrations.) Someone had worked on this carb previously and didn't reinstall the spring for the pilot screw so they had it screwed all the way in so it wouldn't walk out. I checked the floats, no damage or fuel retention. ![]() I'm still having some carb issues, I think.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |